Dull billiard balls: clean them first or send them for restoration?

Use one ball to check what changes after routine cleaning. A chalk mark that lifts, a scratch that stays and a chipped edge each call for a different next step.

Start with a ball you can identify

Take a striped ball with a mark near its number, or a spotted cue ball with a mark beside one of the dots. Turn it under a fixed lamp and note where the mark falls relative to the number or dot. A quick photo from that angle gives you a reference when you pick the ball up again after cleaning.

Follow the care instructions for that particular set

Look up the make and model on the box. For its own phenolic balls, Aramith distinguishes between a cleaner for routine care and a restorer for stubborn spots, followed by its cleaner. For a different make or an unlabelled set, confirm which care method suits the material before treating more balls. Let the test ball dry before examining it.

Check the same mark under the same lamp

Suppose the blue chalk mark beside a stripe lifts, but a fine line across the white number circle remains visible as you rotate the dry ball. Record the two findings separately. The first area can go back into your normal care routine. For the line that remains, ask whether surface restoration would address that specific mark. There is no need to treat the entire set on the strength of that one ball.

Set aside a ball with a chip or crack

If the edge of a mark has a piece missing or a crack runs away from it, keep that ball apart from the set. Identify the damage explicitly when you ask for an assessment. Ask whether the ball can return to play or should be replaced before counting it among the balls for surface restoration. A photograph of a glossy finish cannot answer that question.

Aramith’s care instructions for its phenolic billiard balls

Related reading

A worn cue ball: restore one ball or send the set?